Wireless Access

 View Only
last person joined: yesterday 

Access network design for branch, remote, outdoor and campus locations with Aruba access points, and mobility controllers.
Expand all | Collapse all

Rejoining Access Points from AOS 6.5 to AOS 8.7

This thread has been viewed 35 times
  • 1.  Rejoining Access Points from AOS 6.5 to AOS 8.7

    Posted 14 days ago
    I will install new Aruba 7010 controllers with AOS 8.7 soon. This will replace an AOS 6.5 environment. Once I have installed the new 7010's I want to reprovision the Aruba 305 Access Points that previously were joined on the AOS 6.5 controllers. What is the best way to do this ?

    1. Reprovision the AP's from AOS 6.5 by providing the new controller addresses and reload the AP's ?
    2. Configure the new controller address on option 43 of the Access Point scope / Vlan and reload the AP's ? ( not sure if that is enough)
    3. Configure the new controller address on option 43 of the Access Point scope / Vlan and factory default the AP's with the "paperclip procedure" (not sure if it is required)
    4. Something else ... ?

    Thanks in advance :-)


  • 2.  RE: Rejoining Access Points from AOS 6.5 to AOS 8.7

    EMPLOYEE
    Posted 14 days ago
    #2.  Just make sure that the ap-groups that exist in ArubaOS 6.5 also exist in 8.x​

    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

    HPE Design and Deploy Guides: https://community.arubanetworks.com/support/migrated-knowledge-base?attachments=&communitykey=dcc83c62-1a3a-4dd8-94dc-92968ea6fff1&pageindex=0&pagesize=12&search=&sort=most_recent&viewtype=card
    ------------------------------



  • 3.  RE: Rejoining Access Points from AOS 6.5 to AOS 8.7

    Posted 8 days ago
    Will the 305 AP's need a factory default reset of will reprovisioning from AOS 6 with the AOS 8 controller IP address be enough ?


  • 4.  RE: Rejoining Access Points from AOS 6.5 to AOS 8.7

    EMPLOYEE
    Posted 8 days ago
    You do not need to factory default the 305s.  The ip address would be enough.

    ------------------------------
    Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

    HPE Design and Deploy Guides: https://community.arubanetworks.com/support/migrated-knowledge-base?attachments=&communitykey=dcc83c62-1a3a-4dd8-94dc-92968ea6fff1&pageindex=0&pagesize=12&search=&sort=most_recent&viewtype=card
    ------------------------------



  • 5.  RE: Rejoining Access Points from AOS 6.5 to AOS 8.7

    Posted 6 days ago
    We have just migrated today and it went fine. Created the AP group form AOS6 and reprovisioned the APs. Thanks very much for your input ! .


  • 6.  RE: Rejoining Access Points from AOS 6.5 to AOS 8.7

    Posted 12 days ago
    1.Reprovision the AP's from AOS 6.5 by providing the new controller addresses and reload the AP's.

    I have done this before, it works. 
    just make sure ap provisioning to new controller IP (don't provision wrong address, or that will make a big work to do.)