I appreciate the response but that implies that SW2 which is a Wifi Netgear router, does all the inter-vlan routing. The lab will have 4 VLANs but more dynamic VLANs if / as I set up demos.
As such, what I would liked to have done is simply run a command such as
Inter-VLAN Routing (arubanetworks.com) Or add some set of static routes without pushing all VLANs to use GW of Netgear
(sw0) #show ip route
Codes: C - connected
O - OSPF, O(IA) - OSPF inter area
O(E1) - OSPF external type 1, O(E2) - OSPF external type 2
O(N1) - OSPF NSSA type 1, O(N2) - OSPF NSSA type 2
M - mgmt, S - static, * - candidate default
D - DHCP
Gateway of last resort is 172.16.100.1 to network 0.0.0.0 at cost 1
S * 0.0.0.0 /0 [1] via 172.16.100.1
C 172.16.100.0/24 is directly connected: vlan100
C 172.16.100.254/32 is directly connected: vlan100
(sw0) #
90% of traffic will be VLAN 100 (172.16.100.0/24) to internet , but to have routing would be very useful.
------------------------------
Jeremey Wise
------------------------------
Original Message:
Sent: Sep 03, 2021 06:30 AM
From: Herman Robers
Subject: S2500-48P-4x10G - Router Intervlan Routing
The chapter 18 in the MAS User Guide (L3-routing) should have all the information.
Create VLAN interfaces, configure DHCP/DHCP-relay if your clients need to get an IP, configure the default route.
Then make sure your SW2 can route back to the MAS for the VLANs 101-104 IPs, and that it performs NAT for those ranges as well.
The MAS switch does support NAT as well, but I would leave NAT as close to the ISP as possible.
------------------------------
Herman Robers
------------------------
If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.
In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
Original Message:
Sent: Sep 02, 2021 07:06 PM
From: Jeremey Wise
Subject: S2500-48P-4x10G - Router Intervlan Routing
Yes.. I know older switch, but its what I have to work with.
Firmware: 7.4.1.12
Looking for example of use of L3 basic Inter-VLAN routing table. VLAN ID is third Octet. GW for environment is 172.16.100.1 which is on wifi/ ISP router.
------------------------------
Jeremey Wise
------------------------------