Hello All,
We recently purchased a number of IAP-103 for our wireless deployment.
Currently I have a single IAP-103 configured with a static IP address of 192.168.1.11 and the virtual controller IP as 192.168.1.10, the uplink VLAN is set to 10 (as this is our mangement VLAN).
I have 2 SSIDs, "Staff" on VLAN 100 and "Guest" on VLAN 200. The switch port that the IAP is connected to is configured as a trunk.
interface gigabitethernet1/24
description "WiFi dot1Q"
switchport trunk allowed vlan add 10,100,200
When I connect to either the .10 or .11 address to access the IAP settings the page takes a long time to load and is very unresponsive. I have tried 3 different browsers and upgraded to the latest firmware (version 6.4.2.6-4.1.1.10)
Does anyone have any sugesstions?