Original Message:
Sent: Apr 26, 2024 02:46 PM
From: schmelzle
Subject: Suitable Poe injector or bad setting
Enable Terminal Access in the Advanced Settings under Configuration > System and then SSH into the AP.
https://www.arubanetworks.com/techdocs/Instant_810_WebHelp/Content/instant-ug/prov-iap/access-iap-cli.htm
Then use the information from the link Carson sent to configure and enable IPM.
Original Message:
Sent: Apr 26, 2024 02:36 PM
From: michalkocanda
Subject: Suitable Poe injector or bad setting
Yes, that was my mistake. But how i could enable it? Is it possible without console? If not, how to use console port?
Original Message:
Sent: Apr 26, 2024 12:26 PM
From: chulcher
Subject: Suitable Poe injector or bad setting
You need to enable IPM, not disable.
https://www.arubanetworks.com/techdocs/Instant_810_WebHelp/Content/instant-ug/custom-iap-param/ipm.htm
------------------------------
Carson Hulcher, ACEX#110
Original Message:
Sent: Apr 26, 2024 12:21 PM
From: michalkocanda
Subject: Suitable Poe injector or bad setting
Okay, but, where could i set IPM to disable? Is it possible thru web gui? I don't have console cable.
Original Message:
Sent: Apr 26, 2024 11:54 AM
From: chulcher
Subject: Suitable Poe injector or bad setting
The 315 will run in restricted mode when powered by 802.3af and Intelligent Power Monitoring (IPM) is not enabled. Enable IPM for the AP to operate normally under most circumstances.
------------------------------
Carson Hulcher, ACEX#110
Original Message:
Sent: Apr 26, 2024 11:10 AM
From: michalkocanda
Subject: Suitable Poe injector or bad setting
Hello, I have a question about poe. I have some IAP-315 and need to power over ethernet. Almost everything works good, but power status is 802.3af. Is it necessary to switch on/off something to get full power of APs?
I used poe injector U-POE-at (product list https://dl.ubnt.com/datasheets/poe/PoE_Adapters_DS.pdf) that I had in my office. Could it be caused by wrong type of injector?
Thank for help or type of solution!