Wireless Access

 View Only
last person joined: 22 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Trouble with ENET1 on AP-125

This thread has been viewed 1 times

  • 1.  Trouble with ENET1 on AP-125

    Posted May 14, 2013 10:29 AM
      |   view attached

    Here's the scenario. I have a few pieces and parts for testing and learning set up in my house. My current set up is as follows.

     

    Controller - 620-US

    AP'S

    AP-105 powered by PoE from the controller and set as a mesh portal.

    AP-125 Powered by PD-9001G-AZ PoE+ injector set as a mesh point.

     

    Problem:

     

    I can't seem to get ENET1 to function so I could say use it to connect my Ethernet capable blu-ray or a network printer in the other room. I've attached screen shot of my wired AP profile.

     

    I have both AP's in the same group and under the same profile, is that my problem or am I missing something else that is obvious to the more experienced Aruba masters in this community?

     

    Any assistance is greatly appreciated.

     

    Thanks,
    Jgilb



  • 2.  RE: Trouble with ENET1 on AP-125

    Posted May 14, 2013 11:51 AM

    Hello,

     

    Your port is untrusted, please try to trust the port unless you have a proper AAA profile setup for this.

     

    Otherwise, please provide more information.

     

    Thanks!

     

    GG



  • 3.  RE: Trouble with ENET1 on AP-125

    Posted May 14, 2013 11:51 AM

     

    editing my response since it was already answered