Wireless Access

 View Only
last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

unable to access the MSM415 by hyper terminal

This thread has been viewed 0 times

  • 1.  unable to access the MSM415 by hyper terminal

    Posted Sep 25, 2012 06:50 AM

    I am trying access the MSM415 through hyper terminal with no success.
    I used the correct hyperterminal settings as follows:

     

     Bits per second: 115200

     Data bits: 8
     Parity: None
     Stop bits: 1
     Flow control: None

     

    But am still cannot access the sensor.
    Kindly advise...


    #hyperterminal


  • 2.  RE: unable to access the MSM415 by hyper terminal

    Posted Sep 28, 2012 03:36 AM

    The settings are correct (the MSM415 default).

     

    Make sure you are connected via a genuine serial port. The USB adapters very rarely work at that speed.

     

    If you have an IP address for it (check the DHCP server assignments), you can ssh into it instead. Try a hard reset too (paperclip in the reset hole for 3 LED flashes) in case the config is stopping a DHCP assignment.


    #DHCP