Comware

hello, my problem is I can not access the VLAN interfaces.

The setup is as follows:

vlan interfaces
*1   10.1.1.1/24      up manual
20   10.1.20.1/24   up manual

Active route table

Destination IP Address Mask Protocol Preference Next Hop Interface

0.0.0.0       0.0.0.0 Static         60                           10.0.1.2 Vlan-interface1
127.0.0.0    255.0.0.0 Direct          0                     127.0.0.1 InLoopBack0
127.0.0.1    255.255.255.255 Direct   0      127.0.0.1 InLoopBack0
10.1.20.0    255.255.255.0 Direct   0           10.1.20.1 Vlan-interface20
10.1.20.1    255.255.255.255 Direct  0      127.0.0.1 InLoopBack0
10.1.1.0    255.255.255.0 Direct   0             10.1.1.1 Vlan-interface1
10.1.1.1    255.255.255.255 Direct   0        127.0.0.1 InLoopBack0

port configuration

GE1/0/10 20 Hybrid 1

on port 10 is connected a pc. the gateway to the pc is 10.1.20.1

this pc can not reach the interface vlna , neither can ping it.

the settings right? It can be used as the VLAN interface gateway ?

what's the full config of port 10?

If the device connected on it has an IP address in the correct range and correct subnet mask then no reason it shouldn't be able to ping the vlan interface unless the port settings are incorrect.

Configures the port 10 as the access VLAN 20