I am reaching out for assistance with configuring OSPF between (two firewall) and (two Aruba 5406R zl2 that are connected in VSF mode). When I try to activate OSPF by entering "router OSPF 1" or "router-id", I receive an error message "invalid input". Additionally, I am facing issues assigning an IP address to a port.
I would greatly appreciate if you could answer the following questions:
Is it possible to activate OSPF on a VSF?
Is it possible to assign an IP address to a port on a VSF?
Thank you in advance for your help.
Your best bet for a detailed response would probably be a new thread, but it does seem like your commands are off.
For OSPF the setup would be something like this:
router ospfarea backboneenableint loopback 0ip address 192.168.0.1ip ospf 192.168.0.1 area backbone
I am not sure if any of these commands are disabled for VSF but I don't see why they would be. Here is a useful article on it:
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.