there is no need for user alias here. that setting they way i understand it, is for inbound firewall from network perspective.
------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
------------------------------
Original Message:
Sent: Jun 06, 2024 02:53 PM
From: mvanoverbeek
Subject: Where is the user alias
Hi Ariyap,
I actually gave a very poor example. The screenshot was incorrect. See here a screenshot that shows I am unable to select user from the Firewall Settings inbound Firewall. I used private mode with a Firefox browser, pretty standard.
------------------------------
Martijn van Overbeek
Architect, Netcraftsmen a BlueAlly Company
Original Message:
Sent: Jun 05, 2024 07:37 PM
From: ariyap
Subject: Where is the user alias
it works for me, see if this is a browser issue.
------------------------------
If my post was useful accept solution and/or give kudos.
Any opinions expressed here are solely my own and not necessarily that of HPE or Aruba.
Original Message:
Sent: Jun 05, 2024 08:43 AM
From: mvanoverbeek
Subject: Where is the user alias
Hi,
I am trying to use the built-in Firewall for a microbranch setup and noticed that I can't figure out how to take advantage of the pre-defined "user" alias. When I try to define a Firewall rule and use "network alias" I am just not given that option. Did this alias dissappear or am I looking in the wrong place?
Thanks in advance
------------------------------
Martijn van Overbeek
Architect, Netcraftsmen a BlueAlly Company
------------------------------