Wireless Access

 View Only
last person joined: 3 days ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Wireless trafic issue with VMCs controllers

This thread has been viewed 21 times

  • 1.  Wireless trafic issue with VMCs controllers

    Posted Nov 06, 2023 11:06 AM

    Dear,

    I have an issue with wireless Lan standalone VMC 8.10.8 deploiement.

    I created an SSID and i am able to connect and get an ip address successfully, but when i try to ping or access any thing in the network it does not work correctly even if every thing is allowed (authenticated role)

    The issue is that sometimes it work for few secondes Sometimes it doesn't, somtimes it works for some devices but it does not for others.

    When i ping ressources from the controller with the user Vlan or when i enable source nat  everything works fine.

    Could you please hello me to résolve this issue ?

    Best regards



  • 2.  RE: Wireless trafic issue with VMCs controllers

    Posted Nov 06, 2023 11:41 AM

    Please make sure that (if running ESXi) promiscious mode and forged transmits are enabled. Problem sounds related to that without knowing further details. Other hypervisors than ESXi may have similar things that need to be configured.

    Did you follow this guide, and the troubleshooting steps?

    Your Aruba partner or Aruba TAC should be able to interactively troubleshoot your issue as well...



    ------------------------------
    Herman Robers
    ------------------------
    If you have urgent issues, always contact your Aruba partner, distributor, or Aruba TAC Support. Check https://www.arubanetworks.com/support-services/contact-support/ for how to contact Aruba TAC. Any opinions expressed here are solely my own and not necessarily that of Hewlett Packard Enterprise or Aruba Networks.

    In case your problem is solved, please invest the time to post a follow-up with the information on how you solved it. Others can benefit from that.
    ------------------------------

    Original Message


  • 3.  RE: Wireless trafic issue with VMCs controllers

    Posted Nov 06, 2023 12:07 PM

    Hi,

    Yes, the client is using vcenter 8 and i enabled the promiscious mode and forged transmits for the port group used 

    Best regards


    Original Message


  • 4.  RE: Wireless trafic issue with VMCs controllers

    EMPLOYEE
    Posted Nov 06, 2023 12:16 PM

    I'd recommend contacting the partner you went through for the purchase, your local Aruba SE, or opening a case with TAC for troubleshooting.  There are a lot of moving parts when it comes to a VMC installation and attempting to identify what is going on via this forum will be challenge.

    From your initial description the problem seems to be with traffic handling which could be a misconfiguration of the port group or a LAG/Team configuration on the vSwitch that isn't correct.  Make sure you are only enabling one interface on the VM and that the network adapter maps to the GE0/0/0 on the VMC.



    ------------------------------
    Carson Hulcher, ACEX#110
    ------------------------------

    Original Message


  • 5.  RE: Wireless trafic issue with VMCs controllers

    Posted Nov 09, 2023 10:47 AM

    Hi there.

    • If you config your ssid in tunnel mode then try to change to bridge mode.
    • or you can check the Controller interface (in GUI) was tick with trust


    Original Message