Controllerless Networks

Reply
Highlighted
Occasional Contributor I

6.5.2 software and AP-220

Hey all, 

Looking for a little clarification on the new software that allows you to configure AP's as IAP, RAP, CAP.  Can I upgrade my controller to 6.5.2 and convert an old controller based AP-205 or AP-225 to an IAP to make it controllerless based?  Or is this only available with newer AP models?  Any insight would be appreciated.

 

Thanks,

Mike


Accepted Solutions
Highlighted
MVP Expert

Re: 6.5.2 software and AP-220

You cannot, any pre-UAP APs (currently anything NOT the 203/303, and 365), if it's an AP-XXX, it will ONLY do controller termination. 

 


Jerrod Howard
Distinguished Technologist, TME

View solution in original post


All Replies
Highlighted
MVP Expert

Re: 6.5.2 software and AP-220

You cannot, any pre-UAP APs (currently anything NOT the 203/303, and 365), if it's an AP-XXX, it will ONLY do controller termination. 

 


Jerrod Howard
Distinguished Technologist, TME

View solution in original post

Highlighted
Occasional Contributor I

Re: 6.5.2 software and AP-220

Thank you 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: