Controllerless Networks

Reply
Occasional Contributor II

Adaptive radio management assigned on 2.4GHz

Hi

 

I have 3 x IAP-205H with an Instant Controller but the 2.4 GHz channels used by all 3 IAPs are 11 on each IAP, I have had to use administrator assigned to use the non-overlapping channels (1,6,11) why does it not do this automatically if i use the default adaptive radio managed assigned?

 

The reason I noticed this was because i was getting random disconnects from devices using the 2.4GHz band

 

Thanks

MVP Guru

Re: Adaptive radio management assigned on 2.4GHz

Is ARM enabled? With the defaults ARM will select either 1,6,11. However if the APs are not within earshot of each other and do not detect a sufficient amount of noise/interference then they may select the same channel if this is suitable.


ACMP, ACSA, ACDX #985
If my post addresses your query, give kudos:)
Occasional Contributor II

Re: Adaptive radio management assigned on 2.4GHz

hi where can i tell if ARM is enabled?

 

Thanks Craig

MVP Guru

Re: Adaptive radio management assigned on 2.4GHz

Under RF -> ARM

ACMP, ACSA, ACDX #985
If my post addresses your query, give kudos:)
Occasional Contributor II

Re: Adaptive radio management assigned on 2.4GHz

when u say is arm enabled, i presume it wont work without arm? what exact setting constitutes arm being enabled, i have attached my arm tab screenshot

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: