Does that mean I add the IP for every AP to the Cisco Radius server? When I try to authenticate to the WiFi network, what device is reaching out to the Radius server? This is what I am trying to figure out. I found that if I add 1 AP to the Radius server, I can authenticate, however that is based on a static IP being assigned to the AP. in the case of the RAP unit that is not possible.
Where do I find the IP Address for the VC so I can add it to the RADIUS server?
Ummm no. I am new to this whole VC game so treat this as a total newbie request.
old subject, but for completeness
on GUI on left bottom Info section: Virtual Controller IP
to configure it System > General: Virtual Controller IP, must be in same network as the Instants.
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.