02-27-2014 12:45 PM
I have an Aruba IAP-105, the scenario is my Aruba 105 is connect via PoE set to vlan 30 the IP subnet for Vlan 30 is 192.168.0.x for management only and i want my wireless client to get the IP subnet 192.168.1.x that belong to Vlan 10.
What configuration I need to do in my IAP? I have a Windows DHCP server.
Solved! Go to Solution.
02-27-2014 01:29 PM
Create a wired port profile :
Make it a trunk
Create local centralize scope using the ip address of your DHCP server as the IP helper address (relay)
And then add the VLAN 10 to the network settings
Lead Mobility Architect @WEI
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
02-28-2014 12:10 PM
You're going to need to configure your switchport leading to the IAP to match with same trunking parameters.
no switchport mode access
switchport mode encapsulation dot1q
switchport mode trunk
switchport trunk native vlan 30
switchport trunk allowed vlan 10,30
Re: Aruba 105-IAP DHCP
02-28-2014 12:27 PM - edited 02-28-2014 12:41 PM
After you enter those commands you should be able to do a "show interface trunk" on the switch (if Cisco) and see the port trunking w/ IAP using Native VLAN 30.
If you issue that command and don't see your switchport interface which leads to the IAP on there......then it's not trunking. At that point try a "shut" and "no shut" on the interface.