Controllerless Networks

Reply
Highlighted
Contributor II

Aruba IAP Cluster CONFIGURATION STATUS Unsynchronized

Hello

 

I've an IAP Cluster which has the "CONFIGURATION STATUS Unsynchronized" in Central (Select an IAP - Manage - Overview).

Actual the cluster is only sycronized after a reboot.

All the other clusters have the "CONFIGURATION STATUS Synchronized".

 

Do you have any idea what is the problem and how can it been solved?

 

Kind regards

 

Highlighted
MVP Guru

Re: Aruba IAP Cluster CONFIGURATION STATUS Unsynchronized

Is the cluster connected to Central okay? Whats the output of 'show activate' on the IAP CLI? Does each of the IAPs in the cluster have a subscription assigned within Central?


ACMP, ACSA, ACDX #985
If my post addresses your query, give kudos:)
Highlighted
Contributor II

Re: Aruba IAP Cluster CONFIGURATION STATUS Unsynchronized

The show activate command show the following:

Activate Server: device.arubanetworks.com

Activate Status: success

Aruba Central Server: device-prod2.central.arubanetworks.com

 

I can have access via central to the IAPs so I think the connection is good but there is an issue with the Sync.

 

Firmware Version is: 8.5.0.5_73491

 

Highlighted
MVP Guru

Re: Aruba IAP Cluster CONFIGURATION STATUS Unsynchronized

Can you provide the output of the following? Also to confirm based on your first message, the IAP is sync'd but only after a reboot? What happens/time duration does it take for it to show unsync'd?

 

show ap debug cloud-config-received
show ap debug cloud-data-sent
show ap debug cloud-state


ACMP, ACSA, ACDX #985
If my post addresses your query, give kudos:)
Highlighted
Contributor II

Re: Aruba IAP Cluster CONFIGURATION STATUS Unsynchronized

Unfortunately I don't know if the status is Syncronized after the reboot and change then to unsyncronized. But I can see that the last conig Changed is when I was rebooting them.

 

show ap debug cloud-config-received:

timestamp: 2020-05-19 18:50:00

Airgroupservice airprint: OK

: Syntax error, skipped

exit: OK

 

show ap debug cloud-data-sent:

there is no Output from this show command received

 

show ap debug cloud-state:

A liste of all Clients which are connected to the cluster is received. here I put an example:

<MIB_CLIENT_TABLE> MIB_IS_WIRED(95) = 0
MIB_MAC_ADDRESS(1) = xx:xx:xx:xx:xx:xx
MIB_NAME(2) = xxxxxxxxx
MIB_IP_ADDRESS(5) = 172.29.60.107
MIB_PHY_TYPE(19) = 1
MIB_HT_TYPE(20) = 5
MIB_BSSID(31) = xx:xx:xx:xx:xx:xx
MIB_SNR(48) = 11
MIB_RX_RETRIES(49) = 0
MIB_TX_RETRIES(50) = 163
MIB_OS_TYPE(53) = Apple
MIB_USER_ROLE(80) = xxxxxx
MIB_IPV6_ADDRESS(137) = xxxx::xxx:xxxx:xxx:xxxx
MIB_VLAN(27) = 601
MIB_CLIENT_AUTHTYPE(135) = 0
MIB_CLIENT_AUTHSTATE(136) = 0
MIB_CLIENT_ACTIVE_STATUS(140) = 1
</MIB_CLIENT_TABLE>

 

 

 

 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: