Hello all,
We are in the process of changing all of our access points to IAPs and have been configuring them. We had successfully confgured multiple IAP 305s and a 304 by having them boot with DHCP and then assigning a static address later one, they were all in the same vlan and broadcasting the same SSIDs.
On the 315, I changed the address and followed the same steps as with the other ones but the IAP will not show up inside the virtual controller. I can type in the address of the 315 into a browser and it will route me to the GUI of the virtual controller but the AP will not be listed with the cluster. The system status light is green/flashing so I think the boot is finished.
I tried to upgrade the firmware on all the IAPs and the result is the same.
Does anyone know what might be causing this?