Hi Joseph,
Thanks for the doc you put together and for your time.
We already have the IPA configured as AM and we are doing packets capturing. But what we noticed is the IAP are cycling through the valid channels. For instance we have configured the valid channels for 2.4 Ghz to [1, 6, 11].
But we couldn't figure out how to force
e.g IAP1 to monitor only channel 1
IAP2 to monitor only channel 6
IAP3 to monitor only channel 11.
So when we are capturing if we log into CLI and isssue this command "show ap monitor status" we see AP1 cycling through all valid channels and not staying on 1.
I hope this gives you a better idea about our setup and the issue we are facing.
I have attached a documenet to show the IAP setting and the channel hopping that we observed
Regards,
Hicham