Controllerless Networks

last person joined: 16 hours ago 

Instant Mode - the controllerless Wi-Fi solution that's easy to set up, is loaded with security and smarts, and won't break your budget
Back to discussions
Expand all | Collapse all

IAP 105 Cluster Joining Issue

This thread has been viewed 0 times

  • 1.  IAP 105 Cluster Joining Issue

    Posted Dec 02, 2013 07:01 AM

    We had cluster of 10 IAPs 105 but after rebooting 04 of IAP are down and they are not able to joing cluster the other 6 IAP's are working perfectly fine. i have made the factory default to the problematic AP's but no success. When I plug those AP's they get IP address from the DHCP server their power and ethernet LED flash green but their a/n and b/n LED become RED and and do not join cluster and broadcast SSID, Please advice



  • 2.  RE: IAP 105 Cluster Joining Issue

    Posted Dec 02, 2013 07:16 AM
    Make sure those are in the same country code
    Also check that auto join is on
    Can you console into one of the IAPs ?
    Run the log ap-debug from the virtual controller it might show why it can't join ?
    Are those in the same segment ?


  • 3.  RE: IAP 105 Cluster Joining Issue

    Posted Dec 02, 2013 07:27 AM

     

    Thanks for your response, Please see below reply of your queries.

     

    Make sure those are in the same country code

    YES country code is PK


    Also check that auto join is on

    Auto Join is Enable


    Can you console into one of the IAPs ?

    Not right now because i m not in site


    Run the log ap-debug from the virtual controller it might show why it can't join ?

    Dosn't found anything special. Please do let me know what should i look for


    Are those in the same segment ?

    Yes



  • 4.  RE: IAP 105 Cluster Joining Issue

    Posted Dec 02, 2013 08:30 AM

     

    Did you upgraded recently ? what IAP OS are you running ?

     

    Can you ping those IAPs ?

     

    If you don't see any errors when running the AP-Debug , then run the AP Log System



  • 5.  RE: IAP 105 Cluster Joining Issue

    Posted Dec 04, 2013 02:46 AM
    No we didn't upgrade before the problem.
    Yes we are able to ping Ap from net network device

    Now to avoid down time I have reset all the AP's to factory default and configure them again and now everything working fine. It seems there was some problem with VC because i tried my own demo IAP but it also didn't join the VC cluster.