Forum Français

Reply
MVP Expert

Re: Problème déploiement OVF Clearpass


@jeremy.e wrote:

Hi all,


 

Finally, regarding the 2 NICs, I put them in the same subnet and I'm actually only using the management interface. It's not a clean deployment but I had to fit customer's limitations.

 

Thanks all for your help.

 

Jérémy


You don't get error when set ip address on the same subnet for 2 interfaces ? (when you setup ClearPass, data interface is not mandatory)




PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info


PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info


PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)


PowerArubaIAP: Powershell Module to use Aruba Instant AP




ACMP 6.4 / ACMX #107 / ACCP 6.5
Highlighted
Occasional Contributor I

Re: Problème déploiement OVF Clearpass

You're right, my mistake, I did not configure the Data management interface because I had been prompted with same subnet alert.

Thanks for correcting :).

 

Jérémy

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: