I currently use AirWave to manage about 500 IAPs. I am now looking into using it to manage switch configuration/firmware and have added a few switches to test. I added HP2530-8P and HP2530-24P groups and folders. I then added a test switch with our standard configuration using the "amp-server" command and used it's config to make a template for each group. Only 1 of the 6 I have tried adding after the initial switch will actually verify the configuration. They check-in with AirWave but just stay as "Unknown" for the configuration.
I see that the switches themselves often have logs showing the AirWave server entering an incorrect username/password despite all our switches having the same login credentials. The AirWave server log shows that the SSH timed out. I have upped the SSH timeout setting in AirWave to the max 120 seconds and still nothing.
There are slight revision differences between the switches (part of why I am adding them) so I found other switches with the same version as the working ones and was still not able get the ssh connected. I changed the default SSH credentials for Aruba Switches in Device Setup > Communication and re-added deleted/re-added the switches. Still nothing.
I see on the successful switches that the AirWave system logs in, and enters the following commands:
console local-terminal none
session interactive-mode disable
terminal width 1920
include-credentials
Any ideas as to what is going wrong here?