We just updated our Airwave to version 8.0.0 and are trying to figure out how to get the appRF data from our IAP-105 access points to poplulate in Airwave? Is there a trick to this or is it possible without using a controller? I upgraded the firmware on the access points and can see the appRF data in the Access Point but its not populating the appRF area in the 8.0.0 Airwave.
AppRF in Airwave and IAPs are not supported in the 8.0.0 release. This is only applicable to controller based networks with regards to AppRF data in Airwave
Is this slated to work in a future release?
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.