Hi everyone,
Is it possible to generate a custom report in Airwaves 8.2.1.1 to capture similar information (Source and destination ports) like the cli command on controllers
show datapath session table
TYIA
Hi,
It is not possbile to run report based on port in Airwave.
Regards,
Pavan
While you can't do it currently, it'd be a great feature request to submit into the innovation portal.
@rginRob Gin wrote:While you can't do it currently, it'd be a great feature request to submit into the innovation portal.
This is very true.
Using source NAT means we have, as far as I can see, a very difficult task tracing back to users
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.