05-18-2017 12:41 PM
I have enabled AppRF in my cluster of Instant APs, I can see the AppRF data in GUI but at the same time AppRF in AirWave doesn't show any data. AppRF is also enabled in AirWave under AMP Setup > Additional AMP Services > Enable AppRF Data Collection. My AirWave is version 22.214.171.124 and Enable Instant GUI Config is set to No.
AppRF data is showing in Instant but not in AirWave. Do you know where is the problem?
Solved! Go to Solution.
05-18-2017 01:30 PM
Where do you look in AirWave for AppRF? Do you want to see from a user specific or overall from your group of IAP?
On my AirWave, I go to Home > AppRF
Then you have to browse to your IAP folder. It's over the Home button, you should see the Top folder, if you click on it then you should be able to drill down to your IAP folder.
I have the Instant GUI config enable though, I don't know if it's a pre-requisite.
Re: AppRF works in Instant but not in AirWave
05-18-2017 02:12 PM
Don't worry, it took me a while to figure it out too as since the new interface with 8.2.x.x a lot hs changed! Previously the folder were beside the time selection on the right. It's not intuitive the way it's positionned right now!