Network Management

Reply
Occasional Contributor I

Rogue Devices in AirWave - best practices

Hi

 

I have in AirWave a lot of Rogue devices. 

 

rogue.png

What are the best practices? Should I just delete all of them?

 

Regards


Accepted Solutions
Highlighted
MVP Expert

Re: Rogue Devices in AirWave - best practices

Best practive is to keep low value for rapids retention setting, default Delete rogue value is set to zero days in Rapids>setup page, try set to one or two days and wait for next nightly maintainece to purge all old data. Default nighly maintianence runs at 4:15am everyday.


Pavan Arshewar | ACCP

If my post address your queries, give kudos and accept as solution!
NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.

View solution in original post


All Replies
Highlighted
MVP Expert

Re: Rogue Devices in AirWave - best practices

Best practive is to keep low value for rapids retention setting, default Delete rogue value is set to zero days in Rapids>setup page, try set to one or two days and wait for next nightly maintainece to purge all old data. Default nighly maintianence runs at 4:15am everyday.


Pavan Arshewar | ACCP

If my post address your queries, give kudos and accept as solution!
NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.

View solution in original post

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: