Security

Reply
Highlighted
Contributor II

Implementing Split Tunnel Mode with the VIA Client

Hello,

 

We have the following set up.

 

A cluster of 3 Aruba 7210 Controllers running ArubaOS 8.6.0.

 

We run VIA clients 3.2.* and would like to run Split-tunnel mode for VIA connections, so only traffic into corporate network is tunnelled to the Controller, and all other traffic to other destinations go directly to those external hosts.

I would be grateful if anyone can point me in the right direction, how one would be able to achieve this with the above setup?

 

Thank you in anticipation.

 

Kind regards PM.

Highlighted
MVP Guru

Re: Implementing Split Tunnel Mode with the VIA Client

Highlighted
Contributor II

Re: Implementing Split Tunnel Mode with the VIA Client

Thank you Craig, this seems to contain information on how I should go about solving my need.

 

I will give it a shot during the course of the next few days.

 

Kind regards

PM

Highlighted
Contributor II

Re: Implementing Split Tunnel Mode with the VIA Client

Hello,

 

Thanks once again Craig, I have now got the VIA client to work with Split Tunnel Mode. But I had to delete the VIA profile, then download it, to effect the change.

 

I am wondering if there is any way of pushing out the change to all the 100+ VIA users. Getting them to do the same would be a major support job. Perhaps shooting out an upgrade of VIA clients would solve this?

 

Kind regards

PM

 

 

Highlighted
MVP Guru

Re: Implementing Split Tunnel Mode with the VIA Client

Potentially, without seeing the issue first hand or the logs its difficult to determine what caused the issue. You can certainly upgrade an effected client and see if this resolves it. Probably easier to upgrade the client via GPO then perform the profile deletion.


ACMP, ACSA, ACDX #985
If my post addresses your query, give kudos:)
Guru Elite

Re: Implementing Split Tunnel Mode with the VIA Client

This is what I got from engineering:

 

"Profile refresh happens on disconnect and connect. In iOS and Mac versions of VIA, profile refresh happens immediately on VIA disconnect and connect. In windows, User has to disconnect and connect twice (This is by design).

Please note, In android we have a known limitation and profile refresh is not supported in the current available version of VIA." - a.k.a. You would have to forget and then download the VIA profile for android for this to work.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Aruba Central Documentation
ArubaOS Consolidated Release Notes
Aruba VIA ASE Solution - Configure VIA VPN
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: