Hi,
I have 2530 switches connected between our two offices where the distance is about 200 metres, currently we are using fiber cable as uplink between this two offices, this is the only single point of failure.
Hence we have decided to use wireless point to point connection as backup for fiber, the challenge i am facing here i can't connect both fiber and wireless uplink cable in same 2530 switch, it is creating loop sometimes in the network and causing network disconnection.
Is there a way to configure port/Link failover in both switches...for ex : when fiber port uplink goes down the wirless P2P port should be able to
send packets to gateway or destination.
Also we have configured 3 vlans and tagged on the intrefaces
tagged vlan IDs
Vlan -2,3&4 on interface 10-24
Untagged vlan Id is Vlan-1 on interface 10-24
Uplink interface in Port-24.
Thanks in advance.