Hi Marc,
I'm seeing the same behavior in my lab setup. It appears that the "operational roles" switch when the switch is rebooted:
Dyn-Seg-Demo(tunneled-node-server)# show tunneled-node-server state
Local Master Server (LMS) State
LMS Type IP Address State Capability Role
Primary : 10.1.1.31 Complete Per User Operational Primary
Secondary : 10.1.1.32 Complete Per User Operational Secondary
Switch Anchor Controller (SAC) State
IP Address Mac Address State
SAC : 10.1.1.31 000c29-25137b Registered
User Anchor Controller (UAC) : 10.1.1.31
User Port VLAN State Bucket ID
Dyn-Seg-Demo(config)# show tunneled-node-server state
Local Master Server (LMS) State
LMS Type IP Address State Capability Role
Primary : 10.1.1.31 Complete Per User Operational Secondary
Secondary : 10.1.1.32 Complete Per User Operational Primary
Switch Anchor Controller (SAC) State
IP Address Mac Address State
SAC : 10.1.1.32 000c29-071ba0 Registered
User Anchor Controller (UAC) : 10.1.1.32
User Port VLAN State Bucket ID
I will get this in to R&D to be fixed. The switch should reach out to the primary controller after a reboot first.
A workaround to reset is to disable the tunneled-node-server command:
Dyn-Seg-Demo(tunneled-node-server)# no enable
Dyn-Seg-Demo(tunneled-node-server)# enable
Dyn-Seg-Demo(tunneled-node-server)# show tunneled-node-server state
Local Master Server (LMS) State
LMS Type IP Address State Capability Role
Primary : 10.1.1.31 Complete Per User Operational Primary
Secondary : 10.1.1.32 Complete Per User Operational Secondary
Switch Anchor Controller (SAC) State
IP Address Mac Address State
SAC : 10.1.1.31 000c29-25137b Registered
User Anchor Controller (UAC) : 10.1.1.31
User Port VLAN State Bucket ID
Thanks,
Justin
JUSTIN NOONAN
TECHNICAL MARKETING ENGINEER – ARUBA WIRED INTELLIGENT EDGE
O: +1 916 540 1748 | justin.noonan@hpe.com
8000 FOOTHILLS BLVD | ROSEVILLE, CA 95747 USA