Wired Intelligent Edge (Campus Switching and Routing)

Reply
Occasional Contributor II

Broadcast suppression pps

Hi all,

 

I want to limit the broadcast traffic on uplinks to 300pps.

Is there a CLI command for it? I only see the CLI commands for working with percentages.

 

Kind regards,

Regular Contributor I

Re: Broadcast suppression pps

You can configure percentage or kbp/s. so not in pps, but i think percentage is a always feasible solution.

 

example:

# interface 1/1

# rate-limit bcast in kbps 100

# rate-limit bcast in percentage 5



- - - - Aruba ACCX #748, ACDX #758, ACMP, ACEAP | HPE Master ASE - - - -
- - - - - - - Feel free to give kudos or accept as a solution! - - - - - - - - -
Highlighted
Occasional Contributor II

Re: Broadcast suppression pps

Hi,

 

Is 5 percent not very low? I'm using 25 percent?

 

Kind regards,

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: