Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
MVP

CX switch OVA setup on Windows 10 laptop

I wanted to share this short technote in whcih I’ll go through and setup the virtual environment on Windows 10 laptop to run a number of Aruba CX switch and NetEdit OVA and then to go through basic configuration.

We’ll make use of GNS3, VirtualBox and Aruba switch and NetEdit OVAs.

Hope you’ll find it useful and as always please send through your feedbacks to improve it.


If a reply adequately addresses your issue, please click on the "Accept as Solution"
Highlighted
MVP Guru Elite

Re: CX switch OVA setup on Windows 10 laptop

Thanks,

 

it is also nice to use API !



PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info

PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info

PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)

PowerArubaIAP: Powershell Module to use Aruba Instant AP

PowerArubaMC: Powershell Module to use Mobility Controller / Master


ACMP 6.4 / ACMX #107 / ACCP 6.5 / ACSP
Highlighted
MVP

Re: CX switch OVA setup on Windows 10 laptop

yes very nice collection.


If a reply adequately addresses your issue, please click on the "Accept as Solution"
Highlighted
MVP Guru

Re: CX switch OVA setup on Windows 10 laptop

You can skip the Loopback installation by using network option in virtual box:

- Host-only adapter (you can create one through host network manager)

- or use bridging

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: