We are just now implementing a wireless solution. My engineer that spec'd out the products and design plan has opted for greener pastures leaving me with the implementation. I have zero wireless experience. What I need to do is set up wireless for employees and guest internet access. I have multiple floors. Each floor has a vlan assigned (21 - 27), guest internet is allowed through vlan 4. We have a management vlan (145) that essentially replaces the standard vlan 1 which we have shutdown. . I am utilizing Cisco 3750 switches (stacked) on each floor which connect to a core vss. I have airwave 8.0 installed on the network.
I am working on the first floor initially. I am using one cable to each IAP-255. Initially, the iap's aquired an 10.21 dhcp address. I can access them from ssh as well as webgui.
My cisco switch port is configured as follows
interface FastEthernet2/0/19
description Training RM AP
switchport access vlan 21
switchport trunk encapsulation dot1q
switchport trunk native vlan 21
switchport trunk allowed vlan 2-5,12,21,22,145,401
switchport mode trunk
Should I use vlan 145 as "native vlan" and assign a static IP to the IAP-225 as this vlan does not have dhcp. Currently, the iap has a dhcp address from vlan 21. Both vlan 4 and 21 have dhcp setup. I have many more questions but am looking at some training classes in an effort not to wear out my welcome.
#AP225