Hi all,
We have 2 Aruba Switches in stack. The problem is that we need to replace one of them.
Switch# sh vsf
VSF Domain ID : 1
MAC Address :
VSF Topology : Chain
VSF Status : Active
Uptime : 28d 21h 43m
VSF MAD : None
VSF Port Speed : 1G
Software Version : WC.16.08.0003
Mbr
ID MAC Address Model Pri Status
--- ----------------- ------------------------------------- --- ---------------
1 XXXXXXXXXXXXX Aruba JL261A 2930F-24G-PoE+-4SFP S... 128 Standby
2 XXXXXXXXXXXXXX Aruba JL261A 2930F-24G-PoE+-4SFP S... 128 Commander
We have to replace the 1 member. I have read some information but I want to be sure which is the best precedure to do the replacing.
- Do we have to configure the new unit? Or If it's in factory config it's OK?
-Do we have to stop the second unit when we form the stack?
- Is there any manual to do this step by step?
Many thanks in advance.
Best regards,
Roger