You can add some more best practice settings to a edge interface, like:
interface 1/2
rate-limit bcast in percent 10
rate-limit mcast in percent 10
exit
vlan 2
untagged 1/2
exit
vlan 211
tagged 1/2
exit
spanning-tree 1/2 admin-edge-port
spanning-tree 1/2 bpdu-protection
loop-protect 1/2
loop-protect trap loop-detected
loop-protect disable-timer 300
write memory
The VLAN can be set in both ways in most firmware, like my setup is the classic way and like your setup is a new methode in the newer firmware. As you can see spanning-tree and loop-protection are set from the root level.
The command "show run interface 1/2" will show you all commands together for interface 1/2, also the commands that be set from the root level.
Hope this will help you!