Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

650 Controller mgmt configuration

This thread has been viewed 1 times

  • 1.  650 Controller mgmt configuration

    Posted May 12, 2014 11:51 AM

    Hey all,

     

    Since the 650 doesn't have a mgmt port in the back, is there a way to configure port 1/0 to be the mgmt interface? I tried looking up a basic configuration guide, but I couldn't find one.

     

    Thank you!



  • 2.  RE: 650 Controller mgmt configuration

    EMPLOYEE
    Posted May 12, 2014 11:56 AM

    You can configure a managment VLAN interface, then make the switchport an access port in that VLAN. You can then add ACLs and other restrictions to the VLAN.



  • 3.  RE: 650 Controller mgmt configuration

    Posted May 12, 2014 12:10 PM

    Tim,

     

    Is there no way to configure the mgmt Interface as listed? If not, what's its point?

     

    mgmt int.png



  • 4.  RE: 650 Controller mgmt configuration
    Best Answer

    EMPLOYEE
    Posted May 12, 2014 12:15 PM

    The mgmt interface is always visible in the CLI, but it is not available on platforms without a dedicated mgmt port.

     

    If you type the command below, it will tell you if it is supported on your controller platform.

     

    interface mgmt

     

    intf-mgmt.PNG



  • 5.  RE: 650 Controller mgmt configuration

    Posted May 12, 2014 12:18 PM

    Great, thank you. So instead I'll configure port 1/0 to be the management port then. Thanks for your help.