Wireless Access

Reply
Highlighted
Contributor II

7210 Controller no response

Hi guys,

 

 I met a problem today,my 7210 controller didn't response the command 'show run'.

 

(7210) #show running-config | include "ip route"
Building Configuration...
Module Configuration Manager is busy. Please try later
 
(7210) #show log all 10
 
Jul  6 14:03:45  isakmpd[3587]: PAPI_Send: sendto Configuration Manager failed: Resource temporarily unavailable Message Code 5010 Sequence Num is 15749 
Jul  6 14:03:46  isakmpd[3587]: PAPI_Send: To: 7f000001:8226 Type:0x4 Timed out. 
Jul  6 14:04:01  isakmpd[3587]: PAPI_Send: sendto Configuration Manager failed: Resource temporarily unavailable Message Code 5010 Sequence Num is 15750 
 
And I found someone had the same problem :
 
 
But my IOS have aleady upgraded to 6.4.2.6.
 
Could some tell me how to do ?

Accepted Solutions
Highlighted
Guru Elite

Re: 7210 Controller no response

You should probably open a case.  There are quite a few reasons why this could happen..  high cpu maybe?  If so, TAC would need to analyse your setup to know what is causing the high CPU and figure out if it is an existing or new bug.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Remote Access Point Solution Guide
ArubaOS Consolidated Release Notes
ArubaOS 8 ViA VPN Solution Guide

View solution in original post


All Replies
Highlighted
Guru Elite

Re: 7210 Controller no response

You should probably open a case.  There are quite a few reasons why this could happen..  high cpu maybe?  If so, TAC would need to analyse your setup to know what is causing the high CPU and figure out if it is an existing or new bug.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Remote Access Point Solution Guide
ArubaOS Consolidated Release Notes
ArubaOS 8 ViA VPN Solution Guide

View solution in original post

Highlighted
Contributor II

Re: 7210 Controller no response

I may found the reason which caused my controller kept saying 'Modul is busy'.

I enabled the DPI function.

But is this a bug or something? You can't enable the DPI in the firewall?

Highlighted
Moderator

Re: 7210 Controller no response

You should definitely be able to use DPI. Please open a TAC case.



If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: