Wireless Access

Reply
Highlighted
Frequent Contributor I

AOS 8.3 on Hyper V

Good Afternoon,

 

i would like some help with the operation of this new AOS.  I have a hyper-v server with two HD and 8 GB of RAM.  I loaded P0 and then it stops..The attachements will have configuration of Hyper-V server and the VM.  I have restarted system and each time it stops at this point.

MVP
MVP

Re: AOS 8.3 on Hyper V

Please follow the guide strictly for installation on hyper-v. What version of hyperv do you run? Hv2019 is not supported yet. Also take care you use static mac adresses.

https://support.arubanetworks.com/DesktopModules/Bring2mind/DMX/Download.aspx?TabId=77&DMXModule=512&Command=Core_Download&EntryId=32546&PortalId=0
Kind Regards Marcel Koedijk
HPE ASE Flexnetwork | ACMP | ACCP - Was this post usefull, Kudos are welcome.
MVP
MVP

Re: AOS 8.3 on Hyper V

Please follow the guide strictly for installation on hyper-v. What version of hyperv do you run? Hv2019 is not supported yet. Also take care you use static mac adresses.

https://support.arubanetworks.com/DesktopModules/Bring2mind/DMX/Download.aspx?TabId=77&DMXModule=512&Command=Core_Download&EntryId=32546&PortalId=0
Kind Regards Marcel Koedijk
HPE ASE Flexnetwork | ACMP | ACCP - Was this post usefull, Kudos are welcome.
Frequent Contributor I

Re: AOS 8.3 on Hyper V

Yes, very familiar with this document.  I have followed the directions like a bible. Yet the VM does not go any further, i checked the version of HV and it HV2012.   

Frequent Contributor I

Re: AOS 8.3 on Hyper V

Since I have only one NIC for the VM would that cause an issue.  In the instruction it is asking for a removal of NEtwork Adapter then making a Etherchannel in the next caption?  Could that be the issue....

Super Contributor II

Re: AOS 8.3 on Hyper V

You need 2 network adapters, but not etherchannel.  

Double check the Hardware Acceleration and Advanced Features for these Network Adapters  

These are my working Hyper-V MM:

1.JPG2.JPG

~Trinh Nguyen~
Boys Town
Frequent Contributor I

Re: AOS 8.3 on Hyper V

Good Morning,

I saw the last post, so I move the VM to another server where I could finish testing the new AOS.  So in the documents it tells of going into PowerShell and creating a port-channel.  Is that action still needed if on the GUI I give the server 2 NIC's?

Super Contributor II

Re: AOS 8.3 on Hyper V

These are base on my personal experience, probably not the best pratice:

  • No need to trunk/port channel. I run two VMMs in Vmware and Hyper-V they are not port channel. The guide is problaby there if you want trunk the links.
  • VMM is strict and requires minimum 3 Proc, 6 GB memory or it won’t boot. Hyper-V dynamic memory won’t work, you must assign all 6GB in “Start up memory”
  • It shows my Hyper-V VMM has three NICs. But only the second NIC is in use and it maps to port gig 0/0/0 in VMM.
  • Watch the console for the message if it hangs.
~Trinh Nguyen~
Boys Town
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: