Hey, I am trying to do a full Remote AP configuration on an AP-105 through a console connection but it never works. I restarted an AP that was already configured, and interrupted the boot and captured the configuration that was on it. Then It took a new AP and did set commands for all of the parmeters to duplicate the configuration, but the AP never comes up. I assume I need to do something special with the ikepsk or pappasswd?
apboot> print
bootdelay=2
baudrate=9600
autoload=n
boardname=Talisker
bootcmd=boot ap
autostart=yes
bootfile=mips32.ari
ethaddr=d8:c7:c8:ca:93:13
name=Pilot-AP-93-12
group=TEST-APGROUP
master=10.146.243.50
serverip=10.146.243.50
a_antenna=0
g_antenna=0
ikepsk=A543C3DF489A10FFF6F105BB3C96EFC1FF6306F935CC1BE8092B2316FB8AEE3D
papuser=vzw-rap
pappasswd=89769C8CFF9A1E4627C6692E3D755E666A26FF6300C26149E0346C96F3DE3ECB
usb_type=0
auto_prov_id=0
is_rmp_enable=0
remote_ap=1
priority_ethernet=0
priority_cellular=0
cert_cap=0
mesh_role=0
installation=0
mesh_sae=0
start_type=cold_start
stdin=serial
stdout=serial
stderr=serial
ethact=eth0