Wireless Access

last person joined: 23 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP-125 - How to access apboot> via hyperteminal

This thread has been viewed 2 times

  • 1.  AP-125 - How to access apboot> via hyperteminal

    Posted Dec 05, 2012 02:42 AM

    hey

     

    i need to clear os on an ap-125

     

    however need an idea on where to get started?

     

    can i access the apboot prompt by booting the ap over the lan to give it power?

     

    ive started a connection in hyperterminal and when i power up the ap using the lan i just get a whole heap of jiberish text and dont end up with any apboot> prompt.

     

    can someone please help?



  • 2.  RE: AP-125 - How to access apboot> via hyperteminal

    Posted Dec 05, 2012 03:36 AM

    Plese try follows.

     

    AP Reset Procedure

    10. Connect Console Cable to AP

    11. Pull out power cable of AP and insert again

    12. When screen says "Hit Enter" - Hit Enter

    13. Then, type: "purge" followed by Enter key

    14. Type: "save" followed by Enter key

    15. Type: "boot" followed by Enter key

     

     



  • 3.  RE: AP-125 - How to access apboot> via hyperteminal

    EMPLOYEE
    Posted Dec 05, 2012 06:30 AM
    @paradoxzero wrote:

    hey

     

    i need to clear os on an ap-125

     

    however need an idea on where to get started?

     

    can i access the apboot prompt by booting the ap over the lan to give it power?

     

    ive started a connection in hyperterminal and when i power up the ap using the lan i just get a whole heap of jiberish text and dont end up with any apboot> prompt.

     

    can someone please help?

    Make sure you have "no Flow control" configured on your Terminal Configuration.