We are deploying 5 AP-365 units connected to 72xx controllers running 6.5.4.3.
Most of them get stuck here:
APBoot 2.1.4.7 (build 57679)
Built: 2016-12-08 at 15:43:35
Model: AP-36x
DRAM: 512 MiB
Flash: Detected W25Q32FV_SPI: total 4 MiB
NAND: 128 MiB
After a few minutes, they reboot and do the same. The switch shows link and power, but clearly the AP is not booting.
Two of them I was able to upgrade code to the latest but then they won't talk to the controller because of
SAPD: Rebooting after setting cert_cap=1. Need to open a secure channel(IPSEC)
and also showing as certified-hold-factory-cert. I've changed it to approved but they go back to this mode no matter what.
Another one I am able to boot and factory reset, but after it attempts to convert to a campus AP, it gets stuck on boot like the other ones or gives me an error like this:
APBoot 2.1.4.7 (build 57679)
Built: 2016-12-08 at 15:43:35
Model: AP-36x
DRAM: 512 MiB
Flash: Detected W25Q32FV_SPI: total 4 MiB
NAND: 128 MiB
Power: POE
## Error inserting "filesize" variable, errno=12
## Error inserting "filesize" variable, errno=12
## Error inserting "filesize" variable, errno=12
## Error inserting "filesize" variable, errno=12
...
Is it a bad batch? I don't think it's a power issue. We've tried two different models of Cisco switches (one 802.11af and one 802.11at) and a PoE+ injector with the same results.
TAC issued an RMA for just two units. Any clues?