Good afternoon,
I have an Aruba 7220 controller and AP-335 configured for bridged mode. We have a wired profile setup for bridging to make ENET0 a trunk and allow VLAN 210,211, with 210 being native - That's where we want the AP to get it's IP from. The AP worked fine when it came up initially, and was then provisioned into the AP group that has this wired profile. I was told the switchport was configured to match, but haven't confirmed that. We notice the BSS-Table shows the SSIDs for about 17 seconds and then it drops for 1-2 seconds and then back up same thing. The AP never reboots, just the radios. I confirmed the VLANs are configured on the controllers.
Any idea what could be causing this? I'm still thinking it's switchport related, but need some other input if anyone else has had similar issue.
Thanks.