Hi all,
i am stucked in the state which AP cannot register to controller.
below is my design.
I have two controller form a master/local(Active/Passive) design.
master ip : 172.16.1.1/24
local ip : 172.16.1.2/24
Active controller ip : 192.168.10.2/24
Passive controller ip: 192.168.10.3/24
VRRP IP 192.168.10.1/24
AP vlan/subnet: vlan 100, ip range: 192.168.10.10/24~192.168.10.254/24
two ssid:
a) guest, vlan 200, bridge local.
b) employee, vlan 300, bridge local.
so , the AP port i need to trunk all vlan (100,200,300)
the controller port i just need to trunk vlan 100.
am i concept right??
but the APs are still cannot register on Controller?
would anyone mind give me some idea??
thx a lot.