I have about 55 AP 135's up, yet they all have a flag of "I" which says they are inactive.
Likewise, I have 3 105's up - acting as a monitoring AP, and they are fine.
The issue was the fact that I was missing a VLAN.
How did I figure this out with ease?
-- I jumped on airheads and found a reference to VAPs.
-- I checked my local and checked it's Assigned VAP:
(LocalController)#sh wlan virtual-ap
Virtual AP profile List
-----------------------
Name References Profile Status
---- ---------- --------------
Test-VAP 1
CorpWireless-VAP 1 Invalid: Named VLAN "CorpWireless" is not mapped
Example2-VAP 1
From here,
(LocalController) #show running-config | begin vlan
Building Configuration...
ip radius source-interface vlan 123
!
interface mgmt
shutdown
!
dialer group evdo_us
init-string ATQ0V1E0
dial-string ATDT#777
!
dialer group gsm_us
init-string AT+CGDCONT=1,"IP","ISP.CINGULAR"
dial-string ATD*99#
!
dialer group gsm_asia
init-string AT+CGDCONT=1,"IP","internet"
dial-string ATD*99***1#
!
dialer group vivo_br
init-string AT+CGDCONT=1,"IP","zap.vivo.com.br"
dial-string ATD*99#
!
vlan 123
vlan-name Corp0 pool
vlan-name Corp1 pool
vlan-name Corp2 pool
vlan-name Corp3 pool
no spanning-tree
interface gigabitethernet 1/0
From this point I realized I was missing my named VLAN as I didn't see my vlan range, nor did I see the vlan-name pool tied to that range.
I should have seen:
VLAN 900-999
vlan-name CorpWireless 900-999
Because we use named VLAN Pools, we need to do two seperate config's.
On the master we need to specify the VLAN Pool:
(MasterController)#
(MasterController)# conf t
(MasterController) (conf)#vlan-name CorpWireless pool
On the local:
(LocalController)#
(LocalController)# conf t
(LocalController) (conf)#vlan range 900-999
(LocalController) (conf)#vlan CorpWireless 900-999
In the VAP, exchange the VLAN # for the vlan-name
for i.e.
(MasterController)# conf t
(MasterController) (config) #wlan virtual-ap CorpWireless-VAP
(MasterController) (Virtual AP profile "CorpWireless-VAP") #vlan CorpWireless
(MasterController) (Virtual AP profile "CorpWireless-VAP") #end
Anyone who has this issue, I hope this helps. If I missed anything, please feel free to add/correct.