Wireless Access

last person joined: 5 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

AP225 aggregated ports - configuration required?

This thread has been viewed 0 times

  • 1.  AP225 aggregated ports - configuration required?

    Posted Apr 25, 2016 07:22 AM

    I have a number of AP225 APs being installed without a controller.

     

    I have LACP trunk ports setup on HP 2950 POE+ switches however once I connect both Ethernet ports on the AP I lose IP connectivity - I am unable to see where I apply any configuration to configure aggregated ports on the AP for throughput.

     

    From what I have read I need to add a LMS IP and GRE STRIPING however this seems to be directed towards a controller?

     

    Can someone advise?



  • 2.  RE: AP225 aggregated ports - configuration required?

    EMPLOYEE
    Posted Apr 25, 2016 07:24 AM
    Did you create a trunk on the switch with LACP enabled?


  • 3.  RE: AP225 aggregated ports - configuration required?

    Posted Apr 25, 2016 07:26 AM

    Yes - LACP trunk created on the switch