Wireless Access

Reply
New Contributor

Airplay - Using non-AirGroup image

I have a 650 controller and Airplay been a nightmare for us.

 

At this time I have it working. However I was constantly getting disconnects and after playing flick this switch and test that setting i beleive I have it working.

 

SOOO my question/s are :

 

1. Should I be on airGroup image?

2. I noticed no Airgroup image past 3.4 is this no longer supported for my controller?
 ( hope not just bought this unit )

 

 

Thanks in advanced.

 

Guru Elite

Re: Airplay - Using non-AirGroup image

The last supported AirGroup code train for the 650 controller is 6.1.x. The latest is 6.1.3.6-AirGroup which can be downloaded from the support site (support.arubanetworks.com)


| Tim Cappalli | Aruba Security | @timcappalli | timcappalli.me |

NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
New Contributor

Re: Airplay - Using non-AirGroup image

Sorry, meant to suggest the  6.1.3.4 is the last one with my controller to download.

I see a 6.1.3.6 but again not for my controller

 

Guru Elite

Re: Airplay - Using non-AirGroup image

Hm. I don't see it there either. Can you open a TAC case?


| Tim Cappalli | Aruba Security | @timcappalli | timcappalli.me |

NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: