Wireless Access

last person joined: 10 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

CPBoot on Aruba 3200 Controller

This thread has been viewed 5 times

  • 1.  CPBoot on Aruba 3200 Controller

    Posted Sep 18, 2013 04:15 PM

    I regularly update my ArubaOS on my 3200 controller and I was wondering if I ever need to update the CPBoot version.  I've seen some forum postings of controllers running versions higher than mine so I know updates do exist.  I'm wondering if there is any advantages or disadvantages of doing so.

     

    I'm on CPBoot version 1.1.4.0 (build 16250) which I believe is what my controller shipped with.  It was built 2007-09-20 16:14:24.

     

    Also this begs the questions of where I could get a hold of an update and what the update procedure is.


    #3200


  • 2.  RE: CPBoot on Aruba 3200 Controller

    EMPLOYEE
    Posted Sep 18, 2013 04:23 PM

    No Sir.



  • 3.  RE: CPBoot on Aruba 3200 Controller

    Posted Apr 07, 2017 09:55 AM

    I have a 4302 controller.
    I can not upgrade at all.

    By "cpboot" mode I can not ping the gateway.
    In the "uartb" mode I make the command "" ifconfig eth0 -addr = 10.24.10.200 -mask = 255.255.255.0 "" ping ok, but when upgrading occore below:

    Npboot> ping 10.24.10.210
    10.24.10.210 (10.24.10.210) is alive
    10.24.10.210 (10.24.10.210): 1 packets sent, 1 received
    *** command status = 0
    Npboot>
    Npboot> load -tftp 10.24.10.210:OAW4302_5.0.4.7_34135
    Loader: raw Filesys: tftp Dev: eth0 File: 10.24.10.210: OAW4302_5.0.4.7_34135 Options: (null)
    Loading:
    ........... 262144 bytes read
    Entry at 0x0000000020000000
    *** command status = 0
    Npboot>
    Npboot>

    The firmware does not go through completely.