You can connect to each AP manually and set the channel and power with these commands:
a-channel 132 18
g-channel 1 12
You may even use some kind of script to make the work for you but I didn't find a CLI command to set the mode back to "
Adaptive radio management assigned" when the survey finished. Only GUI.
You may also increase backoff-time:
arm
backoff-time 3600
Chances are you can finish a small survey before arm changes channel.
Hope developers read this thread.
Guys, we need arm freeze!------------------------------
Leonid Tekanov
------------------------------
Original Message:
Sent: Sep 25, 2020 06:19 AM
From: Christoffer Jacobsson
Subject: Can I freeze ARM in an instant cluster?
Hi!
We´re doing post-install validation surveys and I was sure there was a way to "freeze" ARM in Instant so we can perform a full survey knowing that no channels or transmit powers changed. I can´t find a good way, I´ve checked CLI guide and searched the GUI but no luck.
Is there a neat command to achieve this?
Cheers,