Wireless Access

last person joined: an hour ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Configure RAP155 environmental usb settings

This thread has been viewed 0 times

  • 1.  Configure RAP155 environmental usb settings

    Posted Jun 24, 2014 05:08 PM

    My customer deployed a RAP 155 to an international site with no wired internet access and has subsequently purchased a 4G card.  Is there a way to configure the USB modem using the RAP environmental settings to allow the RAP to connect back to a controller?

     

    Thanks

     

    Randy



  • 2.  RE: Configure RAP155 environmental usb settings

    EMPLOYEE
    Posted Jun 24, 2014 06:53 PM

    Yes, but....You would need to have a supported 3g/4g card and carrier...



  • 3.  RE: Configure RAP155 environmental usb settings

    Posted Jun 24, 2014 07:31 PM

    Ok...the card is a Sierra Wireless 320 card which is on the 6.3.1 approved card list on arubapedia/afp.  What parameters can be set by way of the apboot parameters?  thanks...RB



  • 4.  RE: Configure RAP155 environmental usb settings

    EMPLOYEE
    Posted Jun 24, 2014 07:37 PM

    What is the carrier?

     



  • 5.  RE: Configure RAP155 environmental usb settings

    Posted Jun 24, 2014 08:44 PM
    I am fairly certain it's Telstra.
    Thanks Colin...

    RB


  • 6.  RE: Configure RAP155 environmental usb settings
    Best Answer

    EMPLOYEE
    Posted Jun 24, 2014 08:51 PM

    Controller-Based RAP or Before IAP version 3.4.0.4:

     

    usb_dev = 0x0f3d68aa

    usb_init  = 1,0,telstra.bigpond 

    usb_tty = ttyUSB2

    usb_type = sierra-net

     

    IAP version 3.4.0.4 and above:

    modem-country=AUS

    modem-isp=Telstra