Thanks for the replies.
I can only get an apboot> prompt after hitting enter to stop autoboot. Here is the output when it boots. Is that SIGKILL something to note? It just cycles like this:
Verifying checksum...
Booting image...
........................
Aruba Networks
ArubaOS Version 3.3.2.14 (build 21169 / label #21169)
Built by p4build@trinidad.arubanetworks.com on 2009-04-21 at 18:06:55 PDT (gcc version 3.4.3)
BOARD - Merlot
CPU frequency 180.00 MHz
Using 90.000 MHz high precision timer. cycles_per_jiffy=180000
Memory: 27036k/32768k available (1836k kernel code, 5716k reserved, 416k data, 1992k init, 0k highmem)
available.
detected lzma initramfs
initramfs: LZMA lc=3,lp=0,pb=2,dictSize=8388608,origSize=10224640
LZMA initramfs by Ming-Ching Tiew <mctiew@yahoo.com> .............................................................................................................................................................
wdt: registered with refresh
physmap flash device: 400000 at 1fc00000
Macronix Flash MX29LV320A (Top) (User Locked)
phys_mapped_flash: Found 1 x16 devices at 0x0 in 8-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
number of CFI chips: 1
bond0: Atheros AR2313: 00:0b:86:cb:26:d8, irq 4
AP xml model 5, num_radios 1 (jiffies 7129)
radio 0: band 2 ant 0 max_ssid 16
ath_hal: module license 'Proprietary' taints kernel.
ath_hal: 0.9.17.1 (AR5212, AR5312, RF5111, RF5112, RF2413, RF5413)
ath_rate_atheros: Version 2.0.1
Copyright (c) 2001-2004 Atheros Communications, Inc, All Rights Reserved
ath_dfs: Version 2.0.0
Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved
ath_ahb: 0.9.4.5 (Atheros/multi-bss)
devid=0x58
AR2313_REV8
wifi0: Base BSSID 00:0b:86:32:6d:80, 16 available BSSID(s)
edev->dev_addr=00:0b:86:cb:26:d8
wifi0: AP type AP-61, radio 0, max_bssids 16
wifi0: Atheros 2313 WiSoC: mem=0xb8500000, irq=5
net.aruba_asap.br_init = 1
Getting an IP address...
10.125.0.78 255.255.255.0 10.125.0.254
Running ADP...
Done. Master is 0.0.0.0
Sending SIGKILL to all processes.
Please stand by while rebooting the system.
Restarting system.
.
APBoot 1.5.5 (build taylor@harpua-ENG.0000)
Built: 2006-02-24 18:29:36 (with gcc 3.3.1)
CPU: AR2313 MIPS-32 at 180 MHz: 16 kB I-Cache 16 kB D-Cache
Board: Merlot, Local Bus at 90 MHz
DRAM: 32 MB
POST: passed
FLASH: 4 MB
Net: en0 lo0
Hit <Enter> to stop autoboot: 0
Loading FLASH image @ 0xbfc40000... not present
Loading FLASH image @ 0xbfc80000...
Verifying checksum...
Booting image...
........................