Wireless Access

Reply
Highlighted
Occasional Contributor II

DPI inside a master-local setup

Dear Community,

 

I was just wondering on which controller we should activate DPI inside the firewall settings of a master-local setup.

 

Logically I would say that we only need to activate DPI inside the firewall settings of the local controllers as all the end-user traffic is passing through those controllers. I don't think this is needed to activate DPI inside the firewall settings of the master but I didn't find any official documents that can confirm this.

 

If you know more about this topic, many thanks in advance for sharing your info.

 

Best regards,


Accepted Solutions
Highlighted
Guru Elite

Re: DPI inside a master-local setup

The local controller.

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Remote Access Point Solution Guide
ArubaOS Consolidated Release Notes
ArubaOS 8 ViA VPN Solution Guide

View solution in original post


All Replies
Highlighted
Guru Elite

Re: DPI inside a master-local setup

The local controller.

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Remote Access Point Solution Guide
ArubaOS Consolidated Release Notes
ArubaOS 8 ViA VPN Solution Guide

View solution in original post

Highlighted
Occasional Contributor II

Re: DPI inside a master-local setup

Thanks for confirming Colin :-)

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: