Wireless Access

last person joined: 15 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

How to configure Aruba AP 105 to capture packets and including the radiotap header.

This thread has been viewed 0 times

  • 1.  How to configure Aruba AP 105 to capture packets and including the radiotap header.

    Posted Apr 14, 2014 02:45 PM

    Hi all,

     

    I have Aruba AP 105 and configured to capture raw packets. When i sniff packets using Wireshark or OmniPeak, the captured packtes doesn't contain radiotap header which is required to get the RSSI value. Can anybody help?



  • 2.  RE: How to configure Aruba AP 105 to capture packets and including the radiotap header.
    Best Answer

    Posted Apr 23, 2014 05:43 PM

    If you capture with an AirPcap adapter you will see the radiotap info.

     

    When using packet capturing on the AP-105 and sending to OmniPeek, you should see noise floor and signal level in the packet info section of the decode:

     

    decode.jpg