Hi!
I'm a bit confused regard gre tunnel groups.
https://community.arubanetworks.com/t5/Controller-Based-WLANs/L2-GRE-Tunnel-Group/ta-p/233781
https://community.arubanetworks.com/t5/Controller-Based-WLANs/How-to-configure-a-tunnel-group-for-redundancy-of-GRE-tunnels-on/ta-p/234791
Mainly regarding how the setup looks on the datacenter side.
So for example:
Lets say I've got 2 remote controllers and 2 controllers in DC.
remote controllers RC1 and RC2
DataCenter DC1 and DC2
I would setup a GRE tunnel group on RC1 with 2 tunnels one to DC1 and one to DC2. Since it's a part of GRE tunnel group it wouldn't cause a network loop, only one tunnel is actually sending data.
On DC1 I setup 1 GRE tunnel to RC1 and no tunnel group ?
And on DC2 I setup 1 GRE tunnel to RC1 and no tunnel group ?
Correct so far ?
Now if one DC controller fails we have failover.
But what if we need redundancy also on Remote site ?
Wouldn't setting up a gre tunnel on this controller cause a loop ?